Toll Free 1-866-449-5225
shop by brand
Show ALL 23 Brands
Monte Carlo Fans
Period Arts Fans
Monorail and Track
Swing Arm/Task Lamps
Post Mounted Lighting
Deck & Step Lighting
Directional - Accent
Well & Underwater
Request a Return/Replacement
Call 1-866-449-5225 to Get the Best Advice!
Bourbon Street - 52" Short Ceiling Fan by Fanimation Fans
Fanimation Fans - FP580AB-18-S1 - Bourbon Street - 52" Short Ceiling Fan
Roll over image and scroll to zoom
by Fanimation Fans
Item #: FP580AB-18-S1
Antique Brass Finish with Oak/Walnut Blade Finish
Quick Delivery Options
(tell me more)
Request a Quote
Requires a grounded electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit.
Two FK2100 motors—1.8 amps combined, ceiling mounted, reversible (reverse switch located on switch cup housing). No more than 6 fan assemblies or idlers combined per motor. Not recommended for sound-sensitive areas. 220 VAC, 50 Hz, single-speed motor is also available.
Single-speed—approximately 90 rpm.
6 ft. to 16 ft., although system configuration may affect the maximum spacing.
USE OF IDLERS:
Idler assemblies are utilized for the following circumstances:
1) When fan centers exceed 16 ft. (greater than 16 ft. may cause excessive belt sagging).
2) When obstacles prevent direct belting between two fan units.
System layout will determine number of pulleys required. A typical fan assembly will have two pulleys located just below the fan base. In this configuration the pulley will have an adjustment range of approximately 2', allowing for small changes in ceiling elevation.
Belting material included with each system is 1/16' thick, 1-1/8' wide, 40’ long 3-ply brown neoprene (belts are wrapped around the appropriate pulleys, pulled tight enough to remove slack, fastened with pop rivets (kit provided with system) and excess belt cut away. Belting will stretch some with time and use and may require retightened at a later date.
Each system comes complete with all necessary installation hardware, with the exception of required plywood mounting platforms/backing (to be supplied by owner or contractor).
A variety of 4- and 5-blade sets are available. 5-blade sets are available in palm, bamboo, wood and composite materials. 4-blade sets are made of wood and require the use of BH20 series blade holders (not included). 4-blade sets will increase speed and airflow. See our catalog or visit www.fanimation.com for blade options.
View ALL from the Bourbon Street Series
This product is UL Certified.
This product is UL rated for wet locations.
Ceiling Fan Information
Blade Finish Shown:
Number of Blades:
Request More Information about this product
Call us at 1-866-449-5225 or email us here (
Product Questions and Quote Requests
) if you find a
Earn 5% off your order when you join our
Special Buyer Program
Options in this Series:
Special Buyer Program
Do you have a question or comment?
© 2016 LightingandFanPros All Rights Reserved
Your Session ID: